Edmunds Answers questions

Weird, I have a moaning/deep howl when acceerating through 2nd gear (auto trans) on my Ford Econoline E-350. Anyone?

cardav — Fri, 14 Mar 2008 09:19:07 GMT

I have a 1997 Ford van E-350. It has almost 300,000 miles and its been maintained every 3000 miles and trans fluid flushes every 50,000 (auto trans). It just started this moaning/ deep howl only as it goes thru 2nd gear and stopps when we get to 3rd and OD. What could this be? Anyone?

Where should the timing marks be on the cam sprockets when engine is at TDC? Ford E-350.

jca1595 — Mon, 29 Sep 2008 10:55:23 GMT

ford e-350 club wagon 5.4L the book i have is not specific thanks

What tools are required to change the tail lights on a Ford E350 Van?

kathy34 — Fri, 01 May 2009 19:15:51 GMT

I don't have the correct tool to change the light assembly of the tail light for my Ford E350 Van

Cruise control just stopped working on my 1997 Ford Econoline E-350. It has a 6.8 liter V10 Where is the fuse?

cardav — Fri, 11 Jan 2008 11:12:10 GMT

The cruise control on my 1997 ford E-350 van has always worked great. I use the cruise maybe once a week and then one day it stopped working. Anyone know where the fuse is for this?

How can I search by VIN? (Ford E-350)

loomart — Sat, 02 Aug 2008 17:52:16 GMT

I would like to search for the specifications, dimensions and capacities for a vehicle by VIN number.

What is the value of my 2005 Ford E-350 KUV?

woodys — Tue, 23 Sep 2008 16:19:20 GMT

2005 e 350 super duty. 27K miles. Very clean. Knapheide (KUV) package. what is it worth. It is considered a "commercial van" and cannot find a value using the traditional method.

Ford F-350 diesel transmission malfunction.

joeshug — Thu, 30 Oct 2008 11:12:04 GMT

i have a 2000 f-350 powerstroke with a tranny issue. codes are P0567 cruise resume signal malfunction. P0568 cruise set signal malfunction. P0569 cruise coast signal malfunction. P1780 transmission control switch circuit out of range. customer advised that cruise has not worked for some time, however, just recently overdrive light came on and will not go off. transmission has no overdrive. have ran diagnostics for code P1780, switch test, open wires, shorted wires. one problem, my mitchell wiring schematic does not match the PCM pin color code. could this problem be in the PCM. subnote, after asking customer more questions, was informed of aftermarket performance chip installation. i removed chip, but no change. if there is and answer for these codes i would sure be grateful.

C

I have a 1990 Winnebago with a Ford E-350 chassis. Blinkers work but drivers hazard will not flash?

1990winne — Wed, 03 Dec 2008 22:15:36 GMT

I get no voltage to the bulb housing on the driver side when the flashers are on but the turn signals seem to function fine. Could the Flasher circuit run 3 and not the 4th bulb or is it more likely I have a break somewhere? If I have a break where can I get the info on which of the 3 wires should I rerun back to the circuit box to get this to work or can I just cut into the hot lead on the Passenger side and run in to the drivers side to get the light to elum when the other one is going off?

Thanks

Where is the fuel cutoff switch/inhibitor/reset on a 1991 Ford E350 5.8L with dual tanks? It says in the "cab".

islanderjam469 — Mon, 12 Jan 2009 16:57:44 GMT

it seems the fuel cutoff switch was activated and i cannot find the reset switch. when plugged in normal, the external pump doesn't work, but it does when i jump it to a 12volt source.

Is my fuel pump bad? Ford E-350.

mad15 — Tue, 27 Jan 2009 10:01:11 GMT

my truck cuts off going 70mph in a 1985 F350 6.9 diesel. At first the gas went out and the truck wouldn't accelerate. Then after like a mile the truck cut off completely.

I have a 1997 Ford F-350 diesel that turns off while driving. Changed IDM module and cam sensor. Still turns off.

junebug9 — Tue, 24 Feb 2009 21:16:07 GMT

Some times it dies while parked 7.3 diesel automatic 4x4 350

Ford E-350 with rough idle and intakes.

tbucks — Mon, 16 Mar 2009 23:02:47 GMT

Hi,

Thank you for your response. I checked the compression today and it was 140-150 psi and the cylinder head is a re-manufactured head. It only has about 15-20 minutes tops running on it. Do you think it could be an injector, because I am not getting any misfire codes when I run key on engine off and engine running tests. I heard the lower intake on these are plastic, and if you cancel out the cylinders, you can blow these plastic intake apart. Do you know if there is a way to cancel out each cylinder one at a time safely? Thank you! I appreciate your time and knowledge.

TJ

How do you remove a broken nipple from an inline fuel line? This is on a 93 Ford E350. Nothing seems to work.

dftaz — Sun, 17 May 2009 22:37:50 GMT

I just acquired a 93 Ford E350 (motorhome attached) that sat for five years. It obviously needed some TLC which I've been providing. It did start up and run, but was missing, so I've replaced plugs, fuel, air filter, etc.

Today I was changing out the in-line fuel filter. The rear hose came off with no problem. The front hose is a different story.

What ended up happening is that the fuel filter nipple broke off in the front fuel hose fitting. I have been trying to use the disconnect tool to release the internals and remove the fuel filter nipple. There's a small bit to grab on to, but the combination of the disconnect tool and needle nose pliers aren't doing the job.

What's more daunting is looking at the attachment to the motor assembly, so I don't think removing the fuel line is the easiest option.

What can you suggest? Thank you for your time and input.

Smoking and stinking running Ford E-350.

dftaz — Mon, 18 May 2009 20:54:35 GMT

We do have another question that we haven't seen here and that is, now that the fuel filter has been changed, the unit started up - but still smokes like the dickens and smells strongly of gasoline out of the exhaust. It idles very rough and will dies if the accelerator is let up on.

We've replaced the crank case filter, air filter, fuel filter, plugs, wires, cap & rotor as well as verifying clicking noises in the fuel injectors.

Given that this unit has sat for five years and we've replaced the fuel, what other areas do we need to look at?

One other quick question, the fuel fill line isn't crimped - but is leaking fuel. The only way I can see to get to it is to remove the tires. Any other suggestions?

Thanks again for your help!!!

I really need a ballpark mpg please for a 92 Ford E-350 box van with dual wheels. TIA

yvonnerichie — Tue, 26 May 2009 13:07:12 GMT

I realize there are many variables. Any examples would be great. I need to take a light weight load (paintings) from NY to MI, and then return empty.

How do I lift the 6.6 liter engine in a 1981 Ford E-350 RV?

gwg65pd — Wed, 19 Aug 2009 19:48:15 GMT

Change motor in E-350 ford RV 1981.

i have an 89 Ford E150 5.8 with c-6, is there an overdrive transmission i can bolt up without mods?

timcoupe — Wed, 27 Feb 2008 20:48:34 GMT

hoping to be able to get an overdrive transmission or will have to get rid of van due to gas mileage, this is a high top conversion van/camper

Have a deep moaning noise from transmission on my Ford E=350?

cardav — Thu, 20 Mar 2008 10:29:04 GMT

I have a 1997 ford E-350 and it just started this deep moaning noise from trans when accelerating only . Sounds like wind howling. i don't think its the rear end. Van has about 300,000 miles. Noise goes away on freeway if not acceling. any idea's.... Thanks!

2002 Ford E-350 Econoline. Dash board light out, need fuse diagram please. Do not have owner's manual.

kathyy — Sun, 11 May 2008 14:27:13 GMT

2002 Ford Econoline E350 Super Duty Van. The lights on dashboard do not work. Do not have owners manual, need fuse diagram please.

1998 Ford E-350. My right turn signal stopped working and fuse 11 under dash keeps blowing. Replaced multifunction switch.

gfernandez — Sat, 27 Sep 2008 15:02:45 GMT

As stated multifunction switch and flasher replaced. as well as new bulbs. Also went from stem to stern looking for wire shorts.The brake lights don't work either. Cant get tranny out of park unless I turn key to off position then try and it shifts. This just came on suddenly I ran out of things to check any help is appreciated. Only thing I added was a new stereo and I checked that to. Can the shift lockout module be the culprit? Or the brake switch is shorting out. Metered for continuity and switch checks ok. Even shorting the switch wires dont help.

Found a 2002 Ford E350 with 470,000 miles on it. Will this make a full U.S. Tour?

timeghost — Tue, 07 Oct 2008 21:02:18 GMT

Basically what the title says. My band is doing a full U.S. tour. I would assume around 6,000 miles in total. Will this van hold up? The guy said it has a rebuilt tranny. It was used for as an airport shuttle. I'm not a car guy by any means, but if you can help ask important questions, then that would be helpful. Thanks!

Tow rating for a Ford E-350?

casper99701 — Mon, 15 Dec 2008 11:07:56 GMT

Whats the tow rating for a 1993 e350 4.9?

Ford E-350 Power Stroke diesel stalling and mpg.

jchatfield — Mon, 15 Dec 2008 12:54:31 GMT

Hi---you answered my question on Dec 13 Re: 1995 E350 PStroke diesel that stalls like not pushing in the clutch on a standard trans(mine is an automatic OD) The reason I thought it had something to do with the transmission other than the sound and feel of the "stalling" -- is that as long as I remember to put the trans in neutral when coming to a stop is does not stall.I am going to do all that you suggested---it has been at least 15,000 miles since the fuel filter was changed.Also,could you advise me on some basic things I can do to improve the mpg---it gets between 12 and 14--pulling a trailer(8-10,000#) and empty.This E350 is a cab and chassis---short front cab,fiberglass sleeper,and very light 8' flatbed--so overall the unit is lighter than a 4dr dually . Thank you very much. JChatfield

I have a Ford E-350 with 5.4l and have a rough idle seems to smooth out off idle.

tbucks — Sun, 15 Mar 2009 23:38:43 GMT

this 5.4l engine runs rough. there is no service light on and no codes from the computer.had trouble with coolant in cyl #4 and a few times motor seemed to hydro lock a few times but after sitting started up but heavy white smoke out the exhaust.had someone replace the right cyl head and gasket now smoke is gone but has a rough idle.. my question is is it possible to have a bent connecting rod and cause this problem??? thanks for your time and if anyone has some advise on what to check out i would appreciate your help...

Anyone know the weight of the powertrains for the Dodge Sprinter, Ford E350 and Ford Transit Connect?

strickerje — Tue, 09 Jun 2009 17:58:40 GMT

I am interested in knowing the weight of the powertrain (engine, transmission, drivetrain, differential, and other related components) for the U.S.-spec baseline engine and transmission on the following vehicles -

Dodge Sprinter (3.0L Mercedes-Benz OM642 diesel V6 with 5-speed automatic)

Ford E350 (5.4L Ford Triton gasoline V8 with 4-speed automatic)

Ford Transit Connect (2.0L Ford Duratec gasoline I4 with 4-speed automatic)

I am trying to determine the weight of just the basic chassis, that is, the curb weight less the fluids and powertrain. If there's anything else I've neglected to consider, please let me know!

Thanks in advance, everyone!

1997 Ford E-350 7.3 diesel automatic stalls in reverse. Feels like if someone took foot off clutch too early.

sam147 — Wed, 10 Jun 2009 23:23:16 GMT

When first starting vehicle, I can go in reverse just fine. If I go in drive then reverse it stalls, and it sputters out like if someone were driving a standard and took their foot off the clutch too soon.

I have a 1990 Ford E-350 7.3 diesel van. What transmission fluid does it take?

oldtestaments — Sat, 15 Aug 2009 12:55:00 GMT

I need to know what transmission fluid to use in a 1990 Ford E350 7.3 liter Diesel transmission and how much?

I need the wiring and electrical diagrams for the power locks of a 2002 Ford E-350 passenger van.

wilbertog — Mon, 17 Aug 2009 17:33:09 GMT

I just bought a 2002 Ford XLT Super Duty Econoline 15 passenger van for our church. I need the wiring and electrical diagrams for the power locks since these ones are not working, there is not current, I jump the power windows live wire to the power locks and they did work, but only when the ignition is on. I hope some one out there can help me.

Horsepower and torque for Ford van: E-350 7.3L v-8 diesel please? 2001, 2002, 2003?

harmonymtn — Mon, 02 Nov 2009 21:05:12 GMT

I want to tow an RV that weighs about 10,000 lbs and am deciding between the early diesel and the later model v-10 gasoline engines. Thanks.