Answers

Question

Asked: Sep 25, 2008 - 06:02 AM

Status: Closed

maleyann11

How to replace the hazard switch on a 2000 Chevy Impala.

I removed plates from under the dash,can't reach the in dash switch,instrument panel in the way,any sugestions?

In Maintenance & Repair > Electrical > Switches
In Makes & Models > Chevrolet > Impala
1 answer - 427 days ago

Watch this Question | Email to a Friend

Report it

Note: Per our Visitor Agreement, Edmunds.com does not guarantee the accuracy of any answers. We recommend that you use common sense when following any advice found here.

Answers

karjunkie

Date: Sep 25, 2008
Time: 02:03 PM

The front of the dash must be removed in order to get to the hazard/turn signal switch, (not as hard as it sounds). remove fuse panels on both sides of dash. under each remove one screw. Remove two screws above instrument cluster. Unclip panel right above pedals. Remove two more screws. Dash panel should be ready to be removed, remove slowly it is secured by clips all the way across. Before you start, lower the steering wheel to the full down position and have the car's shift lever all the way down into low (I think). The hazard turn switch should be just right of the instrument cluster.

Report it

i have a 99 dodge dakoda sport 6cyl 3.9l 2wd , whe...

I have a 2001 VW Bora. The driver side drainage ch...

2004 Chevy Malibu over heats but really isn't?

have 2000 subaru legacyl/w c/e/light on c/p1507 er...

2003 Toyota Camry power door lock problem

problems with Camry power door locks

Rank	Leader	Points
1.	mr_shiftright	550
2.	docj	290
3.	tony78	240
4.	0patience	175
5.	patrick88	80
6.	canddmeyer	60
7.	subearu	30

2010 Chevrolet Impala

More Pictures

Subscribe to the Edmunds Automotive Network Newsletter and enter the $500 Gas Card Sweepstakes. Sign up now and enter for your chance to win a $500 Gas Card! Official Rules